All locked channels become unlocked and remain unlocked until you turn Onyx EZR Off and back On.

It is your responsibility to determine if you have the knowledge, skills, and physical ability required to properly perform an installation.

SiriusXM shall have no liability for damage or injury resulting from the installation or use of any SiriusXM or third party products.

Just match the colors on the cable ends to the colors on the dock to see what goes where.

Make sure there is ample room for the PowerConnect Vehicle Dock and Onyx EZR Radio when installed.

Set the orientation of the Adhesive Mount before adhering it.

Loosen the knob and adjust the adhesive foot for the location you selected in Step 1: Choose a Location for Your Radio.

TIP Mount the antenna on the roof (for most vehicles) or trunk (for convertibles) where it has a clear view of the sky in all directions CAUTION Dont mount.

Then route your antenna cable according to the step-by-step instructions which follow for your specific type of vehicle.

Feed the antenna cable from the antenna underneath the rubber molding around the rear window.

Use a blunt plastic putty knife or similar blunt tool to lift the rubber molding around the rear window and tuck the antenna cable underneath the molding.

Feed the antenna cable underneath the rubber weather stripping of the rear tailgate window door and route the cable along the rear hatch.

Lift the weather stripping from the opening and tuck the cable inside it, then replace the weather stripping.

Continue tucking the cable underneath the windshield molding around the windshield to the lowest corner.

At the lowest corner of the windshield, route the cable out of the windshield molding and into the rubber weather stripping around the door opening.

Then the installation is complete.

The audio level output of Onyx EZR can be increased or decreased as necessary to match the audio levels of other sources in your vehicle.

Upon power up, Onyx EZR should tune to channel 1 by default, when its not yet activated.

Make sure your Onyx EZR is turned on, tuned to XM Preview channel 1, and receiving the XM signal so that you can hear the XM audio.

The favorite channel preview pane can be toggled by pressing the Select button at the main display screen.

Navigation Buttons Pressing Left, Right, Up, and Down navigates through various features and functions of Onyx EZR.

Once the channel number is entered, the Radio directly tunes to the new channel.

If you want to stay tuned to the channel being played and stop the scan, just press the Select button.

This feature can be turned off so that channels are not tuned automatically if desired.

FM presets are used when you use PowerConnect or the FMDA to listen to your Onyx EZR through your vehicles FM radio.

Refer to Option 3: PowerConnect Installation Instructions on page 22 for more information.).

Sirius Xm Radio Hack